混合系统有望让 AI 数据中心冷却更便宜高效

由 Sadie Harley 编辑,Robert Egan 审阅
本文已按照 Science X 的编辑流程与政策进行审阅。编辑在确保内容可信度的同时,突出了以下特征:
添加到首选来源
图形摘要。图片来源:Journal of Colloid and Interface Science (2027)。DOI: 10.1016/j.jcis.2026.141479
处于人工智能(AI)革命核心的数据中心,有望借助滑铁卢大学正在研发的一种混合冷却系统,以更高效、更经济的方式散热——该系统用一滴沸腾的冷却液精准处理计算机芯片上的热点。
这一新概念将使用廉价去离子水的一般浸没式冷却,与用昂贵冷却液液滴对特别高温区域进行定点冷却结合起来。
“这是一种分工,”滑铁卢大学机械与机电工程学教授 Sushanta Mitra 博士说。“水非常擅长处理稳定的日常热量,而液滴则负责应对突然的热量尖峰。”
热点让传统冷却方式难以招架
为应对庞大而分散的数据中心所产生的巨量热量,运营方越来越多地将芯片、处理器等电子元件浸入专用冷却液中。
视工作负载而定,芯片中的小区域可能在几秒内就比其他区域热得多,导致其降速、加速老化并损害可靠性。仅仅是流经表面的冷却液反应太慢,无法应对这些突发的热点。
沸腾液滴直击多余热量
该研究团队——成员包括博士后研究员 Tian-Yu Zhang 博士和博士生 Arnav Banerjee——在此前工作的基础上,通过用一种液体的薄壳包裹另一种液体来解决这一问题。这项题为“A hybrid immersion cooling assisted by liquid-liquid encapsulation: A game changer for thermal management of transient hotspots”的研究发表在《Journal of Colloid and Interface Science》上。
他们选择了一种沸点远低于水的电子设备冷却液。这种冷却液也比水重,因此不会与水混合,放在热点上时会留在原处。
在实验室测试中,一滴冷却液沸腾后,在 15 秒内使浸没在水箱中的模拟计算机芯片热点温度最多降低 17° C,比传统浸没式冷却快数倍。
“沸腾能吸收大量热量,上升的气泡会搅动周围的水,从而更快地带走热量,”滑铁卢纳米技术研究所执行主任 Mitra 表示。“我们获得了沸腾的效力,但只在需要的地点和时间。”
随后,研究人员用他们的封装技术将冷却液滴包裹在一层薄薄的硅油外壳中。在包覆层中加入微小的导热陶瓷颗粒,有助于控制液滴沸腾的速度。
热点冷却的两条路径
研究人员设想该系统最终以两种方式之一运作——要么是冷却液液滴在水中循环、接触热点时被激活,要么是液滴被直接输送到传感器检测到的热点。
这种混合冷却方案还有望应用于电动汽车、电池、高功率激光器和 LED 照明等技术领域。
Tian-Yu Zhang 等,《液-液封装辅助的混合浸没式冷却:瞬态热点热管理的颠覆性方案》,Journal of Colloid and Interface Science(2027)。DOI: 10.1016/j.jcis.2026.141479
这篇报道的背后是谁?
生命科学与生态学学士。拥有微生物学实验室背景,并具备石油、天然气和可再生能源行业的医药新闻经验。完整简介 →
数学生物学学士,创意写作硕士。游历广泛,对科学与语言有独到见解。完整简介 →
引用:混合系统可使 AI 数据中心冷却更便宜、更高效(2026年11月10日),2026年11月10日检索自 https://techxplore.com/news/2026-11-hybrid-cooling-ai-centers-cheaper.html
本文件受版权保护。除出于私人学习或研究目的的合理使用外,未经书面许可,不得复制本文档的任何部分。本内容仅供参考之用。
获取即时摘要文本(要点)
一种混合冷却系统将去离子水浸没冷却与局部沸腾冷却液液滴相结合,以应对芯片瞬态热点。在实验室测试中,一滴冷却液在15秒内将模拟热点的温度最多降低17°C,速度比传统浸没式冷却快数倍。
本摘要由 LLM 自动生成。完整免责声明
译文由英文原文机器翻译,术语按行业惯例统一,可在文末展开原文核对。
查看英文原文(Hybrid system could make cooling AI data centers cheaper and more efficient)
edited by Sadie Harley, reviewed by Robert Egan
This article has been reviewed according to Science X's editorial process and policies. Editors have highlighted the following attributes while ensuring the content's credibility:
Add to Preferred Sources
Graphical abstract. Credit: Journal of Colloid and Interface Science (2027). DOI: 10.1016/j.jcis.2026.141479
Data centers at the heart of the artificial intelligence (AI) revolution could be cooled more effectively and economically with a hybrid system under development at the University of Waterloo that targets hotspots on computer chips with a single drop of boiling coolant.
The novel concept combines general immersion cooling with inexpensive deionized water and targeted spot cooling of especially hot areas with drops of costly coolant.
"It's a division of labor," said Dr. Sushanta Mitra, a professor of mechanical and mechatronics engineering at Waterloo. "Water is excellent at handling steady, everyday heat and the drops take care of sudden spikes."
Hotspots outpace conventional cooling
To deal with the enormous amount of heat generated in sprawling data centers, operators are increasingly immersing electronic components such as chips and processors in specialized coolants.
Depending on the workload, small areas in chips can get much hotter than others in a matter of seconds, causing them to slow down, age faster and undermine reliability. Coolant that simply flows by is too slow to react to the sudden hotspots.
Boiling drops target excess heat
The research team—which included Dr. Tian-Yu Zhang, a postdoctoral researcher, and Ph.D. student Arnav Banerjee—tackled that problem by building on previous work to encapsulate one liquid in a thin skin of another. The study, "A hybrid immersion cooling assisted by liquid-liquid encapsulation: A game changer for thermal management of transient hotspots," is published in the Journal of Colloid and Interface Science.
They selected an electronics coolant with a much lower boiling point than water. The coolant is also heavier than water, so it doesn't mix with it and stays put when placed on a hotspot.
In laboratory testing, a single drop of coolant boiled and reduced the temperature of a simulated computer chip hotspot submerged in a tank of water by up to 17° C in 15 seconds, several times faster than conventional immersion.
"Boiling soaks up a lot of heat and the rising bubbles stir the surrounding water so it carries heat away faster," said Mitra, executive director of the Waterloo Institute for Nanotechnology. "We get the punch of boiling, but only where and when it's needed."
Researchers then used their encapsulation technique to wrap coolant drops in a thin skin of silicone oil. Adding tiny, heat-conducting ceramic particles to the coating helps control how quickly the drops boil.
Two routes to hotspot cooling
Researchers envision the system ultimately working in one of two ways—either coolant drops that circulate through water and activate when they hit hotspots, or drops that are delivered directly to hotspots detected by sensors.
The hybrid cooling approach also has potential applications in technologies including electric vehicles, batteries, high-powered lasers and LED lighting.
Tian-Yu Zhang et al., A hybrid immersion cooling assisted by liquid-liquid encapsulation: A game changer for thermal management of transient hotspots, Journal of Colloid and Interface Science (2027). DOI: 10.1016/j.jcis.2026.141479
Who's behind this story?
BSc Life Sciences & Ecology. Microbiology lab background with pharmaceutical news experience in oil, gas, and renewable industries. Full profile →
Bachelor's in mathematical biology, Master's in creative writing. Well-traveled with unique perspectives on science and language. Full profile →
Citation: Hybrid system could make cooling AI data centers cheaper and more efficient (2026, November 10) retrieved 10 November 2026 from https://techxplore.com/news/2026-11-hybrid-cooling-ai-centers-cheaper.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.
Get Instant Summarized Text (Gist)
A hybrid cooling system combines deionized-water immersion with localized boiling coolant drops to manage transient chip hotspots. In laboratory tests, one drop lowered a simulated hotspot temperature by up to 17°C in 15 seconds, several times faster than conventional immersion cooling.
This summary was automatically generated using LLM. Full disclaimer
This site uses cookies to assist with navigation, analyse your use of our services, collect data for ads personalisation and provide content from third parties. By using our site, you acknowledge that you have read and understand our Privacy Policy and Terms of Use.
原文为英文,正文由自动抓取并保留原文。
原文发布于 TechXplore(Hybrid system could make cooling AI data centers cheaper and more efficient),标题、摘要与正文由机器翻译,术语按行业惯例统一,未经人工逐句校订。
